Question about Optifit with left handed clubs.
After reading a few threads:
At address with my Epic 3 wood and driver, I can't see the HZRDUS logo. Does this mean it's a right handed shaft? Should the mark at the bottom of the shaft always line up with the mark on the club head?
In the photo below, L-R Driver, 3W, 3H, the cogs on my 3W and 3H are undelrined, the cogs on my driver aren't. If I'm right, I need to reverse the settings on the driver but don't for 3W and 3H?
So my driver is currenty set to Stated loft and Draw (opposite to +1 and N)
3W is +1 loft and Draw
3H is Stated loft and Neutral
@Russell_Coight You are correct on all counts. The LH cog is underlined. For a RH cog, read the info on the clubhead side of the cog instead of where you normally would.
I'm not sure about the logo being upside down. Maybe @jimm9fa7 could help us out...he's a fellow lefty and knows more than a thing or two about building clubs.
@Russell_Coight They put the graphics down on those T800 shafts. Im a righty and my graphics were down too. I think you are okay.
@Russell_Coight I guess the graphics are down because they can be distracting I guess.
@RickM graphics down...except on some of the newer Speeders that have graphics on both sides. I prefer a clean sided shaft.